Large inclination belt conveyor Installation and Use Precautions

2017-04-21

Large inclination belt conveyor can also be considered a consumable, and on weekdays in the delivery and delivery of the process play a great role in the correct installation and normal maintenance is to reduce the occurrence of accidents and extend the life of the transport aircraft.
 Bearing: Crusher bearing the full load of the machine, so good lubrication of the bearing life has a great relationship, it directly affects the machine life and operating rate, which requires the injection of lubricants must be clean, the seal must be good, The main oiling of the machine (1) Rotary bearings (2) Roller bearings (3) All gears (4) Movable bearings, sliding surfaces. 2, the new installation of the wheel prone to loose must be regularly checked. 3, pay attention to the work of the various parts of the machine is normal. 4, pay attention to check the wear and tear of the wear and tear, pay attention to replace the wear parts. 5, put the activities of the chassis plane, should be out of dust and other objects in order to avoid the machine can not break the material when the activities of the bearings can not move on the chassis, resulting in serious accidents. 6, bearing oil temperature rise, should immediately stop the cause of the check to be eliminated. 7, rotating gear in the operation if the impact should immediately stop the inspection and eliminate.
 
Installation test: 1, the equipment should be installed on the basis of the level of concrete, with anchor bolts. 2, the installation should pay attention to the main body and horizontal vertical. 3, after installation, check whether the various parts of the bolt loose and the mainframe door is tight, if any, please fasten. 4, according to the power of the equipment configuration power lines and control switches. 5, check is completed, the empty load test, the test can be normal production.
 
Sprinkle material processing 1. Reproduced at the point of spreading material at the transfer point of the main material is in the hopper, guide trough, etc.. Such as large inclination belt conveyor serious overload, large inclination belt conveyor conveyor tarpaulin rubber skirt damage, guide groove at the steel plate design distance from the belt rubber skirt longer material to the material out of the trough. The above situation can be in the control of transport capacity, strengthen the maintenance on the solution. 2. When the concave radius of the belt is too small, the belt will be vacant when the radius of curvature of the concave section is small. At this time, the belt becomes a change of the groove, because the belt has left the groove roller group, the general groove angle So that part of the material spilled out. Therefore, in the design phase should be used as much as possible a large radius of curvature to avoid such a situation. Such as in the mobile mechanical loading machine, heap reclaimer equipment in order to shorten the tail car and the concave section of this design into a non-circular transition interval, when the belt width is relatively easy to use when the smaller scavenging material. 3. Spreading when the deviation of the sprinkling of the belt when the deviation is due to the two edges in the operation of the height of the two sides have changed, while the other side, while the other side of the material from the low side of the method, the method is to adjust Belt deviation.
Tel:+86 532 67731351