Causes and Solutions of Bearing Heating in Concrete Mixing Plant

2017-10-23

Today, we come to the concrete mixing plant bearing heat causes analysis:
1, first check the amount of grease and the model is appropriate. Clean the bearing seat and the bearing to replace the new grease; in the tightening of the slide on the bolt to add a 10mm thick square pad, and double nut tightening; rack and motor base, slide between the joints with the gap Vibration reduction.
2, vibration will cause the bearing heat. Check whether the rack is fastening, flywheel balance is good, both may cause equipment vibration, if the fly wheel balance is not good, can fly wheel removed, reduce vibration, see whether the bearing is still hot.
3, objective conditions. Whether the external ambient temperature is too high, the external environment temperature is high, concrete mixers and fans and other high speed, bearing and grease lubrication, these conditions are likely to cause high bearing temperature or even fever.
Finally, but also to remind the majority of users are: mixing plant and other equipment, the bearing temperature is too high, try not to use water or thin oil forced lubrication and other complex means, but should use concrete mixer small pulley with fan and other simple measures to assist Cooling, hope that the above content for the enterprise concrete mixing plant to bring the smooth and efficient production
Tel:+86 532 67731351